– 57 –
ENG
ROCKER ARMS, PUSH RODS AND VALVE LIFTERS
INSTALLING THE ROCKER ARMS AND
PUSH RODS
The following procedure applies to both cylin-
ders.
1. Install:
• rocker arms 1
• rocker arm shafts 2
(onto rocker arm base)
NOTE:
The thread hole a of the rocker arm shaft
must face to the outside.
2. Install:
• dowel pins 1
• rocker arm gasket 2
New
3. Install:
• rocker arm base
(with rocker arms)
• push rods
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Put the rocker arm base on the cylinder
head.
b. Install the push rods.
NOTE:
• Be sure to correctly install the push rods
between the rocker arms and valve lifters as
shown. The illustration is viewed from the
right side of the motorcycle.
È
Rear cylinder
É
Front cylinder
1
Intake side rocker arm
2
Exhaust side rocker arm
3
Intake valve lifter
4
Exhaust valve lifter
5
Push rod 1 = 288.5 mm (11.358 in) green
painting
6
Push rod 2 = 290.5 mm (11.437 in) yellow
painting
• The lengths of push rod 1 and push rod 2 are
different. Therefore, be sure to install them in
the proper position.
• Lubricate the push rod end balls with engine
oil.
È
É
Comments to this Manuals