HS80M/HS50M
10
6. TRANS Circuit Board and Power Trans-
former
(Time required: about 2 minutes)
6-1 Remove the rear panel assembly. (See procedure 3.)
6-2 Remove the four (4) screws marked [130]. The TRANS
circuit board with the power transformer can then be
removed. (Fig. 3)
6-3 Unsolder the power transformer mounting solder (6
locations) and separate the power transformer from
the TRANS circuit board.
* The power transformer is not a component of the
TRANS circuit board.
7. AC INLET Circuit Board
(Time required: about 2 minutes)
7-1 Remove the rear panel assembly. (See procedure 3.)
Unsold soldered parts (2 locations) of the power
switch.
7-2 Remove the two (2) screws marked [150]. (Fig. 3)
7-3 Unsold the soldered part of the AC inlet grounding
wire and remove the AC INLET circuit board.
(Photo. 4)
[110]: Bind Head Tapping Screw-S 3x10 (WG341400) +バイン
ドSタイト
[115]: Bonding Tapping Screw-B 3x10 (WH042000) +ボンディ
ングBタイト
[130]: Bind Head Tapping Screw-S 4x10 (WG341300) +バイン
ドSタイト
[150]: Bind Head Screw-S 3x15 (WG341500) +バインド小ネジ
6. TRANSシート/電源トランス
(所要時間:約2分)
6-1 リアパネルAss’yを外します。(3 項参照)
6-2 [130]のネジを4本外し、TRANSシート(電源トラン
ス付)を外します。(図 3)
6-3 電源トランス取付ハンダ(6カ所)を外して、TRANS
シートと電源トランスを分離します。
* 電源トランスはTRANSシートの構成部品ではありま
せん。
7. AC INLETシート(所要時間:約2分)
7-1 リアパネルAss’yを外します。(3項参照)
電源スイッチのハンダを外します。
7-2 [150]のネジを2本外します。(図 3)
7-3 AC INLETのアース線のハンダを外し、AC INLET
シートを外します。(写真 4)
[110]
[115]
[130]
[150]
LEVEL Knob
LEVELつまみ
Fig. 3(図 3)
HS80M
Solder
(ハンダ)
AC Inlet
(AC INLET)
AC INLET Circuit Board
(AC INLETシート)
AC INLET Circuit Board
(AC INLETシート)
Power Switch
(電源スイッチ )
[D]
[E]
[F]
Photo. 4(写真 4)
Photo. 5(写真 5)
Comments to this Manuals