Yamaha YST-SW45 User Manual download pdf (Page 10)

ADJUSTING VOLUME

Front panel

1 Set the VOLUME control to minimum (0).

2 Turn on the other components.

3 Press the STANDBY/ON button to turn on this unit.

4 Play any source and adjust the amplifier’s volume control to the desired listening level.

5 Adjust the HIGH CUT control according to the main speakers connected.

Normally, set the control to the main speaker’s rated minimum reproducible frequency*. If the desired response

cannot be obtained, adjust the control again to your preference.

* The main speaker’s rated minimum reproducible frequency can be looked up in the speakers’ catalog or

owner’s manual.

6 Turn up the VOLUME control gradually to adjust the volume balance between this unit and the

main speakers.

Normally, set the control to the level where you can obtain a little more bass effect than when this unit is not used.

If the desired response cannot be obtained, adjust the control again to your preference.

3 5 1,6

Once the volume balance between this unit and the main speakers is adjusted, you can adjust the volume of your

whole sound system by using only the amplifier’s volume control.

150 Hz

010

50 Hz

STANDBY/ON HIGH CUT VOLUME

20 50 100 200 500Hz

HIGH CUT 100 Hz

HIGH CUT 150 Hz

HIGH CUT 50 Hz

FREQUENCY RESPONSE

This unit’s frequency response

Adjustment of the HIGH CUT control and the VOLUME control needs to be changed according to the main speakers, listening

condition, source, etc.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Yamaha YST-SW45 User Manual Page 10