Yamaha YDP-C71 Owner's Manual download pdf (Page 28)

YDP-C71 Owner’s Manual

Appendix

ENGLISH

Keyboard Stand Assembly

CAUTION

• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance

with the sequence given below.

• Assembly should be carried out by at least two persons.

• Assemble the unit on a hard and flat floor with ample space.

• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.

• Be sure to tighten up all screws upon completing assembly of each unit.

• To disassemble, reverse the assembly sequence given below.

Remove all parts from the package and make sure you

have all of the items.

1 Attach (finger-tighten) C to D and E.

1-1 Untie and straighten out the bundled pedal cord.

Don’t discard the vinyl tie. You will need it later in

step 6.

1-2 Align D and E with each end of C.

1-3 Attach D and E to C by finger-tightening the long

screws 1 (6  20mm).

2 Attach B.

2-1 Place the lower side of B on each foot of D and E,

then attach the upper side to D and E.

2-2 Attach the top of B to D and E by finger-tightening

the thin screws 3 (4 12mm).

2-3 While pushing the lower part of D and E from

outside, secure the bottom ends of B using two

tapping screws 4 (4 20mm).

2-4 Insert the other two tapping screws 4 (4 20mm)

into the other two screw holes to secure B.

Have a Phillips-head (+) screwdriver of the

appropriate size ready.

Bundled pedal cord inside

AC Power cord

Assembly Parts



20 mm long screws



6  16 mm short screws 4

4  12 mm thin screws 2



20 mm tapping screws



5 Cord holders  2

Headphone hanger set

6 4  10 mm thin screws 2 Headphone hanger

1-2

1-1

1-3

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Comments to this Manuals

No comments

Yamaha YDP-C71 Owner's Manual Page 28

Comments to this Manuals

Related products and manuals for Keyboards Yamaha YDP-C71