Yamaha MCR-040 Owner's Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 136
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
14 En
ADDITIONAL INFORMATION
Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
TROUBLESHOOTING
General
Problem Cause Remedy page
This unit fails to turn
on or enters the
standby mode soon
after the power is
turned on.
The unit does not
operate properly.
The power cable is not connected or the
plug is not completely inserted.
Connect the power cable firmly.
4
This unit has been exposed to a strong
external electric shock (such as lightning
or strong static electricity).
Set this unit to the standby mode, disconnect the
power cable, plug it back in after 30 seconds and
then use it normally.
No sound. No appropriate input source has been
selected.
Select an appropriate input source with INPUT on
the front panel (or the source buttons on the remote
control).
Speaker connections are not secure. Secure the connections.
4
The mute function may be on. Cancel the mute function.
6
The volume is turned down. Turn up the volume.
Signals this unit cannot reproduce are
being input from a source component,
such as a CD-ROM.
Play a source whose signals can be reproduced by
this unit.
3
The power is
suddenly turned off.
The sleep timer may be set. This is not malfunction. Turn on the unit and play the
source again.
The unit is left turned on for 1 hour
without playback or any other operation
being performed.
The power was turned on by the timer
and elapsed specified running time.
MCR-140: The iPod selected as the input
source is disconnected from the
transmitter, or does not output sound for a
certain period.
The clock setting has
been cleared.
The power cable has been disconnected. Connect the power cable, and set the clock again.
Sound is heard from
the speaker on one
side only.
Incorrect cable connections. Connect the cables properly. If the problem persists,
the cables may be defective.
4
There is noise
interference from
digital or radio
frequency
equipment.
This unit is too close to the digital or
high-frequency equipment.
Move this unit farther away from such equipment.
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 135 136

Comments to this Manuals

No comments