Yamaha FX Cruiser Operator's Manual download pdf (Page 12)

–8–

Exercise 2: Starting and stopping engine

Drill 2: Stopping the engine

1. Release the throttle lever and let the engine slow to idle.

2. Push the engine stop switch 1 (red button). The ignition circuit opens and stops the

engine immediately.

3. Practice pulling the engine shut-off cord to remove the clip from the engine shut-off switch.

Tips:

1. Attach the engine shut-off cord to your left wrist before starting the engine. To prevent

accidental starting, always remove the clip from the engine shut-off switch when the

engine is not running.

2. Do not operate the start switch for more than 5 seconds at a time. Never push the start

switch while the engine is running.

3. If the engine does not start in 5 seconds, release the start switch and try again after

15 seconds. Continuous cranking for more than 5 seconds will discharge the battery and

the engine will not start.

4. When the engine starts, thrust from the jet unit will move the watercraft. Squeezing the

throttle lever produces more thrust. Apply only enough throttle to keep the engine run-

ning.

E_F1W-12.fm Page 8 Friday, June 11, 2010 3:40 PM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

No comments

Yamaha FX Cruiser Operator's Manual Page 12