Yamaha CDX-E200 Owner's Manual download pdf (Page 5)

CAUTIONS

1 To assure the finest performance, please read this

manual carefully. Keep it in a safe place for future

reference.

2 Install this unit in a well ventilated, cool, dry, and clean

place with at least 10 cm above, behind and on both

sides of the RX-E200 - away from direct sunlight, heat

sources, vibration, dust, moisture, and/or cold.

3 Position this unit away from other electrical appliances,

motors and transformers to avoid humming sounds, do

not place this unit where it may get exposed to rain or

any kind of liquid to prevent fire or electrical shock.

4 Avoid extreme temperature swings or excessive use of

humidifier in the room where this unit is installed to

prevent condensation inside this unit, which may cause

an electrical shock, fire damage to this unit, and/or

personal injury.

5 Do not cover this unit with a newspaper, a tablecloth, a

curtain, etc. in order not to obstruct heat radiation. If the

temperature inside this unit rises, it may cause fire,

damage to this unit and/or personal injury.

6 Avoid installing this unit in a place where foreign

objects and liquid might fall. It might cause a fire,

damage to this unit and/or personal injury. Do not place

the following objects on this unit:

• Other components, as they may cause damage and/or

discoloration on the surface of this unit.

• Burning objects (i.e., candles), as they may cause fire,

damage to this unit and/or personal injury.

• Containers with liquid in them, as they may cause an

electrical shock to the user and/or damage to this unit.

7 Be sure to place this unit on a level surface. If not so,

this unit will fail to work normally and cause damage to

the disc(s) and this unit itself.

8 Do not use force on switches, controls or connection

cables. Never pull the cables when disconnecting them.

9 Only voltage specified on this unit must be used. Using

this unit with a higher voltage than specified is

dangerous and may result in fire or other accidents.

YAMAHA will not be held responsible for any damage

resulting from the use of this unit with a voltage other

than that specified.

10 Do not attempt to clean this unit with chemical solvents;

this might damage the finish. Use a clean, dry cloth.

11 Disconnect the power cord from the wall outlet when

not planning to use this unit for a long period of time, or

during an electrical storm, as they may cause damage by

lightning.

12 Do not attempt to modify or fix this unit. Contact the

qualified YAMAHA service personnel when any service

is needed. Cabinet should never be opened for any

reasons.

13 Be sure to read “Troubleshooting” section regarding

common operating errors before concluding that this

unit is faulty.

PRECAUTIONS: READ THIS BEFORE OPERATING THIS UNIT

This compact disc

player is classified as a

CLASS 1 LASER

product.

The CLASS 1 LASER

PRODUCT label is

located on the rear

exterior.

Laser component in this product is capable of

emitting radiation exceeding the limit for Class 1.

For U.K. customers

If the socket outlets in the home are not suitable for the

plug supplied with this appliance, it should be cut off and

an appropriate 3 pin plug fitted. For details, refer to the

instructions described above.

Note: The plug severed from the mains lead must be

destroyed, as a plug with bared flexible cord is hazardous

if engaged in a live socket outlet.

CAUTION

Use of controls or adjustments or performance of

procedures other than those specified herein may

result in hazardous radiation exposure.

The unit is not disconnected from the AC power source

as long as it is connected to the wall outlet, even if this

unit itself is turned off. This state is called the standby

mode. In this state, this unit is designed to consume a

very small quantity of power.

CAUTION FOR CARRYING THE UNIT

Before carrying the unit, first remove all discs from

the unit, press STANDBY/ON to turn the unit off,

then disconnect the AC power plug from the wall

outlet.

SPECIAL INSTRUCTIONS FOR U.K. MODEL

IMPORTANT:

The wires in the mains lead are coloured in accordance

with the following code:

Blue: NEUTRAL

Brown: LIVE

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured

markings identifying the terminals in your plug,

proceed as follows: The wire which is coloured BLUE

must be connected to the terminal which is marked

with the letter N or coloured BLACK. The wire which

is coloured BROWN must be connected to the terminal

which is marked with the letter L or coloured RED.

Making sure that neither core is connected to the earth

terminal of the three pin plug.

CLASS 1 LASER PRODUCT

LASER KLASSE 1 PRODUKT

LUOKAN 1 LASERLAITE

KLASS 1 LASER APPARAT

1 2 3 4 5 6 7 8 9 10 ... 30 31

Comments to this Manuals

No comments

Yamaha CDX-E200 Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for CD players Yamaha CDX-E200