Yamaha RX-V450 Manual download pdf (Page 22)

CONNECTIONS

Both AM and FM indoor antennas are included with this

unit. In general, these antennas should provide sufficient

signal strength. Connect each antenna correctly to the

designated terminals.

■ Connecting the AM loop antenna

1 Set up the AM loop antenna, then connect it

to the terminals on this unit.

2 Press and hold the tab to insert

the AM loop antenna lead wires

into the AM ANT and GND

terminals.

3 Orient the AM loop antenna

for the best reception.

• The AM loop antenna should be placed away from this unit.

• The AM loop antenna should always be connected, even if an

outdoor AM antenna is connected to this unit.

• A properly installed outdoor antenna provides clearer reception

than an indoor one. If you experience poor reception quality, an

outdoor antenna may improve the quality. Consult the nearest

authorized YAMAHA dealer or service center about outdoor

antennas.

■ 75-ohm/300-ohm antenna adapter

(U.K. model only)

1 Open the cover of the

included 75-ohm/300-ohm

antenna adapter.

2 Cut the external sleeve

of the 75-ohm coaxial

cable and prepare it for

connection.

3 Cut the lead wire and

remove it.

4 Insert the cable

wire into the slot,

and clamp it with

pliers.

5 Snap the cover

into place.

■ FREQUENCY STEP switch

(Asia and General models only)

Because the interstation frequency

spacing differs in different areas, set

the FREQUENCY STEP switch

(locating on the rear panel) according

to the frequency spacing in your area.

• North, Central and South America: 100 kHz/10 kHz

• Other areas: 50 kHz/9 kHz

Before setting this switch, disconnect this unit’s power

cord from the AC wall outlet.

Connecting the antennas

TUNER

ANT

GND

ANT

75Ω UNBAL.

AM loop antenna

(included)

Ground (GND terminal)

For maximum safety and minimum interference,

connect the antenna

GND terminal to a good earth

ground. A good earth ground is a metal stake driven

into moist earth.

Indoor FM antenna

(included)

Notes

11 (7/16)

8 (5/16)

6 (1/14)

Unit:

mm (in.)

Lead wire

Clamp

Insert wire into

slot.

/ 100

/ 50

FREQUENCY STEP

FMAM

00_RXV450_U_EN.book Page 18 Monday, February 16, 2004 7:03 PM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 74 75

Comments to this Manuals

No comments

Yamaha RX-V450 Manual Page 22

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V450