Yamaha RX-V365 Owner's Manual download pdf (Page 14)

100

10 En

Connections

* You can select the front speaker set from Front speakers (A) and Front

speakers (B) by pressing CSPEAKERS repeatedly. See page 19 for

details.

■ Connect speaker cables to each speaker

Cables are colored or shaped differently, perhaps with a

stripe, groove or ridge. Connect the striped (grooved, etc.)

cable to the “+” (red) terminals of your speaker. Connect

the plain cable to the “–” (black) terminals.

■ Before connecting to the SPEAKERS

terminal

A speaker cord is actually a pair of insulated cables

running side by side.

Remove approximately 10 mm (3/8”) of insulation

from the end of each speaker cable and then

twist the bare wires of the cable together to

prevent short circuits.

■ Connecting to the FRONT A terminals

1 Loosen the knob.

2 Insert the bare end of the speaker wire into

the slit on the terminal.

3 Tighten the knob to secure the wire.

■ Connecting to the FRONT B, CENTER, and

SURROUND terminals

1 Press down the tab.

2 Insert the bare end of the speaker wire into

the hole on the terminal.

3 Release the tab to secure the wire.

Speakers Jacks on this unit

a Front speaker (A) Right* FRONT A (R)

b Front speaker (A) Left* FRONT A (L)

c Surround speaker Right SURROUND (R)

d Surround speaker Left SURROUND (L)

e Center speaker CENTER

f Front speaker (B) Right* FRONT B (R)

g Front speaker (B) Left* FRONT B (L)

h Subwoofer SUBWOOFER

10 mm (3/8”)

Red: positive (+)

Black: negative (–)

Red: positive (+)

Black: negative (–)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 99 100

Comments to this Manuals

No comments

Yamaha RX-V365 Owner's Manual Page 14

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V365