Yamaha EM5014C User Manual download pdf (Page 27)

Front & Rear Panels

EMX5014C Owner’s Manual

Reference

Rear Panel

h SPEAKERS jacks

Use these jacks to connect to speakers. Note that the

output directed to these jacks varies according to the

setting of the POWER AMP switch Y.

A1, B1: NEUTRIK NL4 Speakon outputs. Polarities

are as shown below.

A2, B2: Phone output jacks.

i POWER Switch

This switch turns the EMX power ON and OFF. The

POWER indicator U lights up when this switch is on.

Before turning the power ON or OFF, be sure to turn

both the ST master fader and the AUX1 and AUX2

faders are all the way down.

j AC IN Connector

Connect the included power cable here. Connect one

end of the cord to this connector, and then plug the

other end into a standard power outlet.

Before turning the power ON or OFF, be sure to turn

both the ST master fader and the AUX1 and AUX2

faders are all the way down.

k Ground Screw

For maximum safety be sure to securely connect the

EMX to an earth connection. The supplied power cable

has a three-prong plug that will ground the unit when

the plug is inserted into an appropriately grounded

three-prong type AC mains outlet. If the AC outlet is

not grounded, be sure to ground the unit by using this

ground screw. Correct grounding will effectively elim-

inate hum noise and interference.

jk i

Neutrik Plug A1 and B1 Connectors

1–

2–

2+ 2-

1- 1+

–

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 36 37

No comments

Yamaha EM5014C User Manual Page 27