Yamaha RIO3224-D User's Guide download pdf (Page 12)

6. Click [Next].

NOTE

・“upgrade_tool.exe” may be blocked by the Windows Firewall. For Windows XP, click [Unblock] in such case.

For Windows 7, select the [Private Network] checkbox and click [Allow access].

7. Check the Rio to update.

Check the version of the update files and the version number indicated in the Rio line.

NOTE

・If it is not indicated, click [Refresh]. It is still not indicated after that, the computer and the Rio is not

connected properly. Check that the cable does not come off or is not disconnected, TCP/IP is properly configured,

and the Rio is activated.

8. Click [Start].

The update operation will begin.

“Updating(n/m)” appears in the Status field during updating. “Done” is displayed once update is completed.

Update takes 2 to 4 minutes. During the update operation, do not turn off the power to the unit or disconnect the

cable. If update fails due to disconnection of the power cable during the update, or due to other reasons, the device

may become inoperative.

NOTE

・If update is not completed after 5 minutes, or update failure indication appears, click X at the upper right corner

of Dante Firmware Update Manager to exit the program without turning the Rio power off, and restart the

procedure from the step 4. If update still fails, follow the instructions stated in “About Failsafe Mode” to perform

the recovery processing.

9. Turned off the power to the Rio and dip switch setting is returned to the original setup.

Please return a setup of dip switch settings to a setup whose note was made in the update step 3 of the "Updating

the Rio firmware."

The firmware update is now complete.

1 2 ... 7 8 9 10 11 12 13 14 15

No comments

Yamaha RIO3224-D User's Guide Page 12