DSP-AX2
DSP-AX2
14
FULL BIT [Remote control code: 7A—92 (PRG11)]
• The head margin is unused and the digital data is output in full bit.
• The same applies as “DSP 0dB” except that the digital data is output in full bit at D/A but
SWFR is not output in full bit.
2. HP ROUTE (Headphone route)
There are two sub-menu items (0dB, FULL BIT).
0dB [Remote control code: 7A—93 (PRG12)]
• The input signal is automatically identified and switched in the priority order of dts ➝ DOLBY
DIGITAL ➝ PCM AUDIO ➝ Analog (A/D) according to the signal detection.
• L/R, C/RC, FL/FR, RL/RR and SWFR signals are output through DSP (see the signal
path in the figure below) without using the external DRAM.
(The SDOB output is inputted to DAC of MAIN L/R. Other than that, everything is the
same as DSP THROUGH.)
SWFR
RL
RR
FL
FR
C
RC
L
R
FILTER
DF1704
FILTER
DF1704
FILTER
DF1704
D/A
PCM1704
D/A
PCM1704
D/A
PCM1704
CODEC
(D/A)
AK4527
L/R
L/R
L
R
L/R
L/R
L/R
SDOA0
SDOB0
SDOB1
SDOB2
SDOB3
CODEC
(A/D)
AK4527
DIR
PCM THR
MAIN
DSP
(Decoder)
SUB DSP
DIGITAL
ANALOG
AC3D3 YSS928
4M DRAM
1. DSP THROUGH
FULL BIT
2. HP ROUTE
0dB
(In the case of 2-ch source)
Note: (SDOxx) represents a terminal name of AC3D3.
The shaded square ( ) means that the element included in it does not operate.
Head margin
MAIN L/R: -18dBFS
CENTER: -6dBFS
REAR CENTER: -3dBFS
FL/FR: -6dBFS
RL/RR: -18dBFS
SWFR: Add L/R signal at -20dBFS.
Condition
Both ch, -20 dBV, volume -10dB
MAIN L/R
-13.5 dBV
CENTER
-7.5 dBV
REAR C
-10.5 dBV
SWFR
-1.5 dBV
REAR L/R
-1.5 dBV
FRONT L/R
-7.5 dBV
Reference (PRE OUT)
INPUT : DVD ANALOG
SWFR: 50Hz, Others: 1kHz
Condition
Both ch, -20 dBV, volume 0dB
MAIN L/R
-3.5 dBV
CENTER
– ∞ dBV
REAR C
– ∞ dBV
SWFR
– ∞ dBV
REAR L/R
– ∞ dBV
FRONT L/R
– ∞ dBV
Reference (PRE OUT)
INPUT : DVD ANALOG
SWFR: 50Hz, Others: 1kHz
Comments to this Manuals