Yamaha TSS-10 User Manual download pdf (Page 16)

TROUBLESHOOTING

Refer to the chart below when this system does not function properly. If the problem you are having is not listed below

or if the instruction below does not help, set this system to the standby mode, disconnect the power cable, and contact

the nearest authorized YAMAHA dealer or service center.

Problem

The amplifier unit

fails to turn on when

STANDBY/ON ( )

is pressed, or enters

in the standby mode

soon after the power

has been turned on.

No sound.

No sound from the

rear speakers

No sound from the

center speaker when

the DTS or

DIGITAL mode is

selected.

No sound from the

subwoofer.

A “humming” sound

can be heard.

The amplifier unit

does not operate

properly.

There is noise

interference from

digital or high-

frequency equipment,

or the amplifier unit.

No sound from the

center and rear

speakers though the

DTS or DIGITAL

mode indicator is

dimly illuminated.

Cause

The power cable is not connected or the plug

is not completely inserted.

The amplifier unit has been exposed to a

strong external electric shock (such as

lightning and strong static electricity).

Incorrect input cable connections.

An appropriate input source has not been

selected.

The speaker connections are not secure.

The volume is turned down.

The sound is muted.

The level of the rear speakers is set to

minimum.

The surround mode is off.

The source encoded with a Dolby Digital or

DTS signal does not have a center channel

signal.

The level of the subwoofer is set to minimum.

Incorrect cable connections to the ANALOG

INPUTS jacks.

The internal microcomputer has been frozen

by an external electric shock (such as

lightning or excessive static electricity) or by

a power supply with low voltage.

The amplifier unit is too close to the digital or

high-frequency equipment.

Dim illumination of an indicator means that

signals encoded with the corresponding

format (DTS or Dolby Digital) is inputted to

this system. In this case, the signals are mixed

into 2 channels and reproduced from the front

speakers only.

Remedy

Firmly connect the power cable.

Set the amplifier unit in the standby mode,

disconnect the power cable, plug it back in after

30 seconds, then start operating.

Connect the cables properly. If the problem

persists, the cables may be defective.

Select an appropriate input source with the

INPUT button.

Secure the connections.

Turn up the volume.

Press MUTE or any operation buttons to cancel

a mute and adjust the volume.

Press REAR + button on the remote control to

increase the level.

Select the appropriate surround mode by

pressing the MODE button.

Press S. WOOFER + button on the remote

control to increase the level.

Firmly connect the audio plugs to the

ANALOG INPUTS jacks. If the problem

persists, the cables may be defective.

Disconnect the power cable from the outlet and

then plug it in again after about 30 seconds.

Move the amplifier unit further away from such

equipment.

Press the MODE button for the appropriate

surround format. The indicator turns bright, and

the center and rear speakers reproduce sounds

since the surround format is decoded.

Refer

to page

—

8 – 9

—

TSS-10Eng(UB)a 02.7.31, 2:35 PM14

1 2 ... 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Yamaha TSS-10 User Manual Page 16

Comments to this Manuals

Related products and manuals for Acoustics Yamaha TSS-10