Yamaha NS-5 Owner's Manual download pdf

Thank you for selecting this Yamaha NS-5 speaker system.

NS-5

Natural Sound

Bass-Reflex Type

2-Way Speaker System

PRECAUTIONS

Read these precautions carefully before operating

your speaker.

● When using an amplifier with a rated output power

higher than the music input of the speaker, care

should be taken never to exceed the speaker’s

music input.

● Anytime you note distortion, reduce the volume con-

trol on your amplifier to a lower setting. Never allow

your amplifier to be driven into “clipping”.

● Do not place the speaker where it will be exposed to

direct sunlight or excessive humidity to prevent it

from being damaged.

● Do not attempt to clean the speaker with chemical

solvents as this might damage the finish. To clean,

wipe with a dry, soft cloth.

● Placing the speaker on the same shelf or rack as

the turntable can result in feedback.

● Do not place the speaker where it is liable to be

knocked over or struck by falling objects. Stable

placement will also ensure better sound perfor-

mance.

● Secure placing is the owner’s responsibility.

YAMAHA shall not be liable to any accident

caused by an improper placing of the speaker.

Note

Do not let the bare speaker wires touch each other

as this could damage the speaker and/or the

amplifier.

* Banana Plug connections are also possible. First

tighten the terminal knobs, and then insert the

Banana Plug connector into the corresponding ter-

minal hole.

BEFORE MAKING CONNECTIONS, MAKE SURE

THAT THE AMPLIFIER IS SWITCHED OFF.

■ CONNECTIONS

● Connect the screw-type input terminals at the rear

of the speaker to the speaker output terminals of

your amplifier with the provided speaker cables.

● One side of the speaker cable is marked by a white

line. Connect the (+) terminals on both the amplifier

and the speakers using this white-marked side.

Connect the (–) terminals on both components

using the unmarked side of the cable. If connected

with reversed polarity, the sound will be unnatural

and lack bass.

Procedures:

➀ Loosen the terminal knob.

➁ Insert the bare wire end properly into the terminal

hole. [Remove approx. 10 mm (3/8”) insulation

from the speaker cable.]

➂ Tighten the knob.

➃ Test the security of the connection by tugging

lightly on the cable at the terminal.

Black(–)

Loosen

Tighten

Red (+)

White line

CONNECTION TO YOUR AMPLIFIER

1 2

Summary of Contents

Page 1 - CONNECTION TO YOUR AMPLIFIER

Thank you for selecting this Yamaha NS-5 speaker system.NS-5Natural Sound Bass-Reflex Type 2-Way Speaker SystemPRECAUTIONSRead these precautions caref

Page 2 - REMOVING THE FRONT COVER

SPECIFICATIONSType ......2 way bass-reflex speaker systemMagnetic-shielding type (EIAJ)Speaker Unit....13 cm cone woofer (JA13

Comments to this Manuals

No comments

Yamaha NS-5 Owner's Manual

Browse online or download Owner's Manual for Loudspeakers Yamaha NS-5. Yamaha NS-5 OWNER'S MANUAL [en] User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Loudspeakers Yamaha NS-5