Yamaha AG06 Specifications download pdf

General Specifications

0 dBu = 0.775 Vrms, Output impedance of signal generator (Rs) = 150 Ω

All level controls are nominal if not specified.

Frequency Response

Input (MIC) to MONITOR OUT

via USB IN/OUT

+0.5 dB/-1.5 dB (20 Hz to 48 kHz @ Fs = 192 kHz),

refer to the nominal output level @ 1 kHz, GAIN knob: Min, TO PC: DRY CH1-2

Total Harmonic Distortion *1

(THD+N)

Input to MONITOR OUT

0.05% @ 0 dBu (20 Hz to 20 kHz), GAIN knob: Min

0.01% @ +4 dBu (1 kHz), GAIN knob: Min

Hum&Noise *2

(20 Hz to 20 kHz)

Equivalent Input Noise -128 dBu (Mono Input Channel, Rs: 150 Ω, GAIN knob: Max)

Residual Output Noise -103 dBu (MONITOR OUT, MONITOR knob: Min)

Crosstalk (1 kHz) *3 -80 dB

Input Channels

Mono (MIC/LINE): 2 including HEADSET MIC (Plug-in Power)

(CH1 MIC and HEADSET MIC cannot be used simultaneously.),

Stereo (LINE): 2, USB IN: 1, AUX IN: 1

Output Channels

STEREO OUT: 1, MONITOR OUT: 1, PHONES: 2 including HEADSET PHONES

(PHONES and HEADSET PHONES cannot be used simultaneously.)

Bus Stereo: 1

Input Channel Function

(CH1, CH2)

PAD 26 dB

DSP

CH1: COMP/EQ, EFFECT (SPX Reverb)

CH2: AMP SIM, EFFECT (SPX Reverb)

PEAK LED LED turns on when the signal reaches 3 dB below clipping level.

Level Meter USB Output Level 2x2 point LED meter [PEAK, SIG]

USB Audio 2 IN / 2 OUT USB Audio Class 2.0 compliant, Sampling Frequency: Max 192 kHz, Bit Depth: 24-bit

Phantom Power Voltage +48 V

FOOT SW EFFECT Mute on/off

Power Requirements DC 5 V, 500 mA

Power Consumption Max. 2.5 W

Dimensions (WxHxD) 155 mm x 63 mm x 202 mm (6.1” x 2.5” x 8.0”)

Net Weight 1.0 kg (2.2 lbs)

Included Accessory

USB Cable (1.5 m), CUBASE AI DOWNLOAD INFORMATION, Owner’s Manual,

Technical Speciﬁcations (this leaﬂet)

Optional Accessory Foot Switch: FC5, Mic Stand Adaptor: BMS-10A

Operating Temperature 0 to +40°C

*1 THD+N is measured with 22 kHz LPF.

*2 Noise is measured with A-weighting filter.

*3 Crosstalk is measured with 1 kHz band pass filter.

The contents of this manual apply to the latest specifications as of the printing date. Since Yamaha makes continuous improvements to the product, this manual may not apply to the speci-

fications of your particular product. To obtain the latest manual, access the Yamaha website then download the manual file. Since specifications, equipment or separately sold accessories

may not be the same in every locale, please check with your Yamaha dealer.

Analog Input Characteristics

0 dBu = 0.775 Vrms

Input Jack

PAD

26 dB

GAIN

Trim/SW

Position

Actual

Load

Impedance

For Use with

Nominal

Input Level

Connector

Sensitivity *1 Nominal

Max. Before

Clip

MIC/LINE 1 - 2

HEADSET MIC

OFF

3 kΩ

1.5 kΩ *4

50–600 Ω

Mics/Lines

-72 dBu

(0.195 mV)

-60 dBu

(0.775 mV)

-50 dBu

(2.451 mV)

Combo jack *2

(Balanced)

3.5 mm Phone jack

For CH1 HEADSET MIC

(Plug-in Power/

Unbalanced)

-26 dBu

(38.84 mV)

-14 dBu

(154.6 mV)

-4 dBu

(489.0 mV)

-46 dBu

(3.884 mV)

-34 dBu

(15.46 mV)

-24 dBu

(48.90 mV)

0 dBu

(775.0 mV)

+12 dBu

(3.085 V)

+22 dBu

(9.757 V)

INPUT CH2

GUITAR *5

OFF

1 MΩ -

-68 dBu

(3.085 mV)

-56 dBu

(1.228 mV)

-46 dBu

(3.884 mV)

Phone jack *3

(Unbalanced)

-22 dBu

(61.56 mV)

-10 dBu

(245.1 mV)

0 dBu

(775.0 mV)

-42 dBu

(6.153 mV)

-30 dBu

(24.51 mV)

-20 dBu

(77.5 mV)

+4 dBu

(1.228 V)

+10 dBu

(2.451 V)

LINE

3/4, 5/6

HIGH

10 kΩ 600 Ω Lines

-20 dBu

(77.5 mV)

-8 dBu

(308.5 mV)

+2 dBu

(975.7 mV)

LINE 3/4 Phone jack *3

(Unbalanced)

LINE 5/6 RCA pin

(Unbalanced)

LOW

-10 dBu

(245.1 mV)

+2 dBu

(975.7 mV)

+12 dBu

(3.085 V)

AUX - - 10 kΩ 600 Ω Lines

-14 dBu

(154.6 mV)

-8 dBu

(308.5 mV)

+2 dBu

(975.7 mV)

Stereo mini jack

*1 Sensitivity is the lowest level that will produce an output of +0 dBu (0.775 V) or the nominal output level when the unit is set to maximum gain.

(All level controls are at their maximum position.)

*2 1&Sleeve = GND, 2&Tip = HOT, 3&Ring = COLD

*3 Tip = Signal, Sleeve = GND

*4 For CH1, HEADSET MIC

*5 For CH2, GUITAR switch is ON

Analog Output Characteristics

0 dBu = 0.775 Vrms

Output Terminal

Actual Source

Impedance

For Use with

Nominal

Output Level

Connector

Nominal Max. Before Clip

STEREO OUT [L, R] 150 Ω 10 kΩ Lines

0 dBu

(0.775 V)

+10 dBu

(2.451 V)

Phone jack *6

(Impedance Balanced)

MONITOR OUT [L, R] 150 Ω 10 kΩ Lines

0 dBu

(0.775 V)

+10 dBu

(2.451 V)

Phone jack *6

(Impedance Balanced)

PHONES 120 Ω 40 Ω Phones 1.5 mW + 1.5 mW 6 mW + 6 mW

Stereo phone jack

Stereo mini jack

*6 Tip = HOT, Ring = COLD, Sleeve = GND

Digital Input / Output Characteristics

Terminal Format Data Length Sampling Frequency Connector

USB USB Audio Class 2.0/ Yamaha Steinberg USB Driver 24-bit 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz USB Standard-B

ZN24170

MIXING CONSOLE

Technical Specifications

1 2

Summary of Contents

Page 1 - Technical Specifications

General Specifications0 dBu = 0.775 Vrms, Output impedance of signal generator (Rs) = 150 ΩAll level controls are nominal if not specified.Frequency R

Page 2 - Jack and Plug List

Comments to this Manuals

No comments

Yamaha AG06 Specifications

Browse online or download Specifications for Audio mixers Yamaha AG06. Yamaha AG06 Specification User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Audio mixers Yamaha AG06